September 30, 2009

Part 5: Working to the ends of the cord


<--part 4
5.1 Follow the original lead around the tube until you run out of slack.

5.2 When that happens, reverse the tube placing the slack loops on your right. Begin from the point you stopped and remove the slack by pulling the loops through one at a time until you reach the end.

5.3 Continue following the original single lead keeping parallel and on the same side of the cord. Keep working back and forth round the knot until the two leads are overlapping each other.

pre-made herringbone rope bracelets are available in these online shops:
WhatKnotShop on Etsy
WhatKnotShop on Zibbet

part 6 -->

start over

No comments:

Post a Comment